![]() (2, 09:08 AM)SnowLeopardFPV Wrote: So are you able you able to actually put the FC into bootloader mode when holding down the boot button and plugging in the USB cable (i.e. Any suggestions would be greatly appreciated.ĭrone: GepRC Smart 35HD BNF (installed ELRS reciever) At this point I'm not sure what to try next to fix the this issue. I have also tried the ImpulseRC driver fixer and it also was not able to connect to my FC. I have been able to connect to the FC via BF to update the configuration, but from what ive read it uses a different driver in order to flash the firmware? Normal start up has a series of blue/red flashing lights. I have confirmed that with and without the wires soldered I can hold the BL button on the FC and it will enter what I think is BL mode when plugging in the USB. It was suggested that maybe the ELRS receiver was preventing it from going into bootloader and try de-soldering the rx/tx wires. I have confirmed that it is not going into DFU mode automatically when I am flashing. When I go to flash the firmware it gives me an error "failed to open serial port". I'm trying to flash BF 4.3 Howels version in an attempt to get RSSIdB and LQ on my DJI OSD. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |